 |
If
you have an underwater bath light fitted to your bath
you will need
to use the wiring diagram on the left.
Before making the connections on the left the whirlpool
should be
tested with temporary connections between
the ELCB and the pump.
The air tube should be connected
directly to the pump for
testing purposes.
Following
the test do not switch the pump off using the control
on
the bath, instead use the test button on the ELCB.
Then remove all connections from the pump and connect
as the diagram on the left.
Following
the instructions above will leave the pump air switch
in the on position which is required to allow correct
operation when using the control box, and also test
the ELCB, which is required at least on a monthly
basis. |
|
